Barracuda Networks 4 Spezifikationen PDF herunterladen (Seite 19)

Administrator’s Guide

Installing and configuring the Barracuda Web Filter 19

Figure 2.1: Connecting the Barracuda Web Filter to your Network

The Barracuda Web Filter supports 10BaseT, 100BaseT, and Gigabit Ethernet (higher end models

only).

Do not connect any other cables to the unit. The connectors on the back panel are for diagnostic

purposes.

3. Connect the following hardware to your Barracuda Web Filter:

• Power cord

• VGA monitor

• PS2 keyboard

After you connect the AC power cord, the Barracuda Web Filter may power on for a few

seconds and then power off. This behavior is normal.

4. Press the Power button located on the front of the unit.

The login prompt for the administrative console displays on the monitor, and the power light on

the front of the Barracuda Web Filter turns on. For a description of each indicator light, refer to

Understanding the indicator lights on page 43.

Step 3. Configure the Barracuda Web Filter IP and network settings

The Barracuda Web Filter is assigned a default IP address of 192.168.200.200. You can change the

address using the administrative console or by pressing and holding the RESET button on the front

panel.

Holding RESET for eight seconds changes the default IP address to 192.168.1.200. Holding the

button for 12 seconds changes the IP address to 10.1.1.200.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 91 92

Keine Kommentare

Barracuda Networks 4 Spezifikationen Seite 19